We care about every single details of design process from single element to complex structure. Our goal is to achieve functional and aesthetic specification for our valued customers.
We provide product realization solution to our valued customers. This includes concept discussion in the early stage, prove of concept during design phase, prototyping verification and full production support.
This is the initial phase where an idea of new product is generated and documented. EG R&D has the up-to-date knowledge and experience team to review the concept layout and provide the options available and recommendations to our customers.
Once a concept or direction is selected, our team will push the design even further to come out with products that are creative and innovative. We will use your ideas along with your company’s portfolio to design and develop products that completely fit to your Company and your customers’ needs. Each of the products is developed with care and meticulous attention to design.
Depending on the customer requirements, the design activities shall either end at the design stage or continue to development stage. If only design is needed, upon end of the design activities, all the copies of drawings and other design data will be released to our customers.
Once 2D and 3D designs are approved and accepted by our customers, our team will build and test the prototypes. Upon successful testing of the final prototypes built using production level drawings and other documentation, the product is ready for production. Also at this phase, the initial manufacturing procedures are worked out and any necessary manufacturing documentation is created if required.
Product Tooling includes plastic tool fabrication and metal tool fabrication. We will work with customer’s production and engineering team during the building of tooling / moulds process. We will also review and selection of suppliers' quotes for the production and able to work with the suppliers selected by our customers or use of our pre-approved suppliers.
Our sister companies, SMT Technologies Sdn Bhd and EG Operations Sdn Bhd are providing electronic manufacturing services for electrical and electronic products, box build as well as plastic injection molding.
Once the final prototype is tested, validated, accepted and approved by our customers during engineering or pilot run, we will transfer the knowledge and all documentation including design, BOM, specification details to our customers or our sister companies (if selected as manufacturer) for mass production and full product launch.
Lintang Mayang Pasir 3, 11950
Bayan Baru, Penang,
Tel : +(604) 645 9882
Fax : +(604) 646 9882
© 2016 EG R&D
All rights reserved.